Installation Of Indoor, Outdoor Unit - LG ABNW366KSA1 Service Manual

Installation of Indoor, Outdoor Unit

Selection of the best location
1) Indoor unit
Install the air conditioner in the location that satisfies the
following conditions.
• The place shall easily bear a load exceeding four
times the indoor unit's weight.
• The place shall be able to inspect the unit as the fig-
ure.
• The place where the unit shall be leveled.
• The place shall allow easy water drainage.(Suitable
dimension "H" is necessary to get a slope to drain as
figure.)
• The place shall easily connect with the outdoor unit.
• The place where the unit is not affected by an electri-
cal noise.
• The place where air circulation in the room will be
good .
• There should not be any heat source or steam near
the unit
2) Outdoor unit
• If an awning is built over the unit to prevent direct sun-
light or rain exposure, be careful that heat radiation
from the condenser is not restricted.
• There should not be any animals or plants which could
be affected by hot air discharged.
• Ensure the spaces indicated by arrows from the wall,
ceiling, fence or other obstacles.
Installation of Indoor, Outdoor Unit
Inspection hole
Top view
Control box
(unit: mm)
600
Front view
More than
30cm
F e
n c
o b
e o
s t a
r
c l e
s
more than
25cm
more than
75cm
(600X600)
600
Front
H
More than
30cm
More than
70cm
more than
25cm
Service Manual 27