Fujitsu PRIMERGY BX400 User Manual page 22

The system page for advanced mode
Power Consumption
This field is a link to the Information / Operation → Operation → Power Management → Configuration page
in the navigation tree. It indicates the Operation Mode configured.
You configure the Operation Mode in the Configuration tab by selecting the Consumption Mode item in the
Power Consumption Options block using the pull-down menu; then you select the mode you require. The
possible modes are: none, Minimum, Low Noise, Enforced, Limitation, Scheduled. After you actuate Apply,
the mode selected is displayed in the status frame after the colon.
For details, please refer to
Scheduled Consumption Mode: off⏐on
This field indicates whether Power Consumption Mode is switched on or off.
This icon is optional and is displayed only if a USB stick is connected to the Master Management Blade.
⏐
You use the Locate button to switch the blade server's and management blade's ID LED on (blue) or off
(gray).
In the 2nd line (bar chart) the current primary input power of the PSUs and the maximum possible power
consumption of the active PSUs are displayed in the form of a bar chart and in figures in watts.
The 3rd line provides information about the secondary output power which is still available for the blades
up to the specified upper limit, which is dynamic. This value is changed by the system if you set the PSU
Dynamic Mode option (in the Power Consumption Options block of the Power Management → Configuration
page).
I
If you have configured a "Consumption Limitation" (Power Consumption Options → Consumption
Mode → Consumption Limitation) using the Power Management → Configuration menu item, the
values set are displayed in color in the bar chart – in the example below a Limit Threshold of 80%
(red) and a Warning Threshold of 40% (yellow):
Figure 5: Power Consumption diagram with display of the Limitation Threshold (yellow and red)
For details, please refer to
System Unit Details
This button enables you to collapse the status frame.
I
The gray bar at the bottom of the status frame normally only contains the name of the component selected
on the right. However, if you have selected a server blade, this bar (plus the line below it) contains
additional information elements just for this blade (see figure):
Figure 6: Additional status frame for a selected server blade
The Remote Management button takes you to a website where you can administer the blade remotely. You
use the Video Redirection button to open a virtual console for the blade.
22
Mode: none⏐Minimum⏐ Low Noise⏐Enforced⏐Limitation⏐Scheduled
chapter "Power management" on page
chapter "Power management" on page
29.
29.
ServerView BX400 Management Blade S1
Web user interface