Camera Cabling; Connect Power; Connect Ethernet Cable; Connect Alarm I/O - Optica DV104, DV204M User Manual

2.

Camera Cabling

Please follow the instructions below to complete IP Camera connection.
2.1

Connect Power

Please refer to
the camera's PoE port and plug the other end of the cable into a PoE switch.
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in
use in the network.
2.2

Connect Ethernet Cable

Use of Category 5 Ethernet cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet cable to the RJ-45 connector of the IP Dome
Camera, and the other end of the cable to the network switch or PC.
NOTE: In some cases, you may need use an Ethernet crossover cable
when connecting the IP Dome Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs; if the LEDs are
unlit, please check LAN connection.
2.3

Connect Alarm I/O

The camera equips one alarm input and one relay output for alarm application.
Refer to alarm pin definition below to connect alarm devices to the IP Camera if
needed.
6
Section: Connectors. Alternatively, connect the Ethernet cable to
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
PIN 1: GND (Input-)
PIN 2: Input+
PIN 3: Output-
PIN 4: Output+