Guidelines For Treatment; Average Treatment Time - Philips SC2002 User Manual

Photoepilator

Hide thumbs Also See for SC2002:

Manual (186 pages)

Table of Contents

Available languages

Area

Underarms

Bikini line

Entire bikini area

One lower leg

One full leg

Upper lip/ chin/ sideburns

, The 'ready to flash' light on the back of the appliance lights up green

when all contact switches of the safety ring are in contact with the

skin and the device is charged. This may take up to 3.5 seconds.

Tip: For easier use, stretch the area of skin you want to treat. On areas with

softer skin, you may need to exert more pressure on the appliance to push in

all contact switches.

Press the flash button to release a flash.

Note: The visible light produced by the appliance is the reflection of the flash

on the skin and is harmless to your eyes. It is not necessary to wear goggles

during use.

Let go of the flash button after the appliance has flashed.

For the next flash, repeat steps 6 to 9. After each flash it takes up to

3.5 seconds until the appliance is ready to flash again.

Do not treat exactly the same area multiple times during one session.

This does not improve the effectiveness of the treatment, but increases

the risk of skin reactions.

To avoid untreated areas, always make sure there is some overlap

with the previously treated area when you place the appliance on the

skin.The effective light only comes out of the light exit window. Make

sure the flashes are produced close to each other.

Switch off the appliance after you have finished the treatment.

Check the light exit window and the attachment for hairs and

dirt and clean the appliance after use (see chapter 'Cleaning and

maintenance').