Dell OptiPlex GX1 User Manual page 134

Messages and Codes: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
Non-system disk or disk error
Not a boot diskette
Plug and Play Configuration
Error
Read fault
Requested sector not found
Reset failed
Sector not found
Seek error
Shutdown failure
Time-of-day clock stopped
file:///C|/infodev/2013/eDoc/OpGX1/UG/messages.htm[2/21/2013 11:47:24 AM]
The diskette in drive A or
your hard-disk drive does
not have a bootable
operating system installed
on it.
There is no operating
system on the diskette.
The system has
encountered a problem in
trying to configure one or
more expansion cards.
The operating system
cannot read from the
diskette or hard-disk
drive.
The system could not find
a particular sector on the
disk, or the requested
sector is defective.
The disk reset operation
failed.
The operating system is
unable to locate a sector
on the diskette or hard-
disk drive.
The operating system is
unable to find a specific
track on the diskette or
hard-disk drive.
A chip on the system
board might be
malfunctioning.
The battery may be dead. Enter the
A nonbootable diskette is in drive
A. Either replace the diskette with
one that has a bootable operating
system, or remove the diskette
from drive A and restart the
computer.
Boot the computer with a diskette
that contains an operating
system.
Turn your system off and unplug
it. Remove all but one of the
cards. Plug in your system and
reboot it. If the message persists,
the expansion card may be
malfunctioning. If the message
does not appear, turn off the
power and reinsert one of the
other cards. Repeat this process
until you identify the
malfunctioning card.
See "Troubleshooting
See "Troubleshooting
See "Troubleshooting
If the error is on the diskette
drive, try another diskette in the
drive.
Run the System Set Test Group
in the Dell Diagnostics.
System Setup program
and correct the date or time.
If the problem persists, see
Drives."
Drives."
Drives."