Dell OptiPlex GX1 User Manual page 133

Messages and Codes: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
Memory address line failure at
address, read value expecting
value
Memory allocation error
Memory data line failure at
address, read value expecting
value
Memory double word logic failure
at address, read value
expecting value
Memory odd/even logic failure at
address, read value expecting
value
Memory write/read failure at
address, read value expecting
value
Memory size in CMOS invalid
Memory tests terminated by
keystroke
No boot device available
No boot sector on hard-disk
drive
No timer tick interrupt
file:///C|/infodev/2013/eDoc/OpGX1/UG/messages.htm[2/21/2013 11:47:24 AM]
One or more DIMMs may
be faulty or improperly
seated.
The software you are
attempting to run is
conflicting with the
operating system or
another application
program or utility.
One or more DIMMs may
be faulty or improperly
seated.
The amount of memory
recorded in the system
configuration information
does not match the
memory installed in the
computer.
The memory test did not
complete.
The computer cannot find
the diskette or hard-disk
drive.
The system configuration
information in System
Setup may be incorrect,
or the operating system
may be corrupted.
A chip on the system
board might be
malfunctioning.
See "Troubleshooting System
Memory."
Turn off the computer, wait 30
seconds, and then turn it on. Try
to run the program again. If the
problem persists, contact the
software company.
See "Troubleshooting System
Memory."
Reboot the computer. If the error
appears again, see "Getting
Help" for instructions on obtaining
technical assistance.
Rerun the memory test.
Enter the System Setup
check the system configuration
information for the diskette and
hard-disk drive, and if necessary,
correct the information.
Enter the System Setup
check the system configuration
information for the hard-disk
drive, and if necessary, correct
the information.
If the message persists, reinstall
your operating system. See the
documentation that came with
your operating system.
Run the System Set Test Group
in the Dell Diagnostics.
program,
program,