Cleaning Blockages From The Milk Pipework - Miele CVA 6401 Operating And Installation Instructions

Cleaning blockages from the milk pipework

If you notice that the quality of the milk
froth is not satisfactory, this could be
caused by a blockage in the air intake
tube. Follow the instructions in "Step 2:
Cleaning the air intake tube and the
angled connector in the inside of the
machine front"
If only steam instead of milk is coming
out of the central spout, follow the
instructions in Steps 1 to 4.
First check that the milk in the milk
flask has not gone sour as this can
block the milk pipework.
Follow the steps in the cleaning
procedure below to clean blocked milk
pipework. After cleaning, check that the
process for heating and frothing milk is
working well and that the quality is now
satisfactory.
If the process for heating and frothing
milk is still not working well and the
quality is still not satisfactory, do not
make any drinks and repeat the steps
as described.
70
Step 1: Cleaning the milk
pipework in the lid of the milk
flask
^ Pull milk suction tube a out of the
milk flask lid.
Ensure that you also remove seal b
when doing this.
^ Clean both under running water.
Insert the cleaning brush supplied
into the stainless steel tube and move
it back and forth until all milk deposits
have been removed.
^ Also use the cleaning brush to clean
the milk pipework in the lid.