ZyXEL Communications P-660R-Tx Series Support Notes page 25

(2) TCP/IP configuration
Since the P-660R-Tx is set to DHCP server as default, so you need only to
configure the workstations as the DHCP clients in the networking settings. In
this case, the IP address of the computer is assigned by the P-660R-Tx.
The P-660R-Tx can also provide the DNS to the clients via DHCP if it is available.
For this setup in Windows, we check the option 'Obtain an IP address
automatically' in its TCP/IP setup. Please see the example shown below.
Set up your P-660R-Tx under routing mode
The following procedure shows you how to configure your P-660R-Tx as
Routing mode for routing traffic. We will use Web Configurator to guide you
through the related menu.
(1) Configure P-660R-Tx as routing mode and configure Internet setup
parameters in Web Configurator, Advanced Setup, Interface Setup ->
Internet -> Encapsulation.
All contents copyright © 2010 ZyXEL Communications Corporation.
P-660R-Tx Series Support Note s
25