Programming The Camera - Honeywell HD4D3S Configuration Manual

Programming the Camera

The camera is programmed using the on-screen display (OSD) menus. You may need to connect a
portable monitor during installation using the supplied adapter cable.
To access the OSD menu system, press the OSD controller joystick located on the camera control
board. Move the joystick left or right, up or down, to navigate through the menus. Menu icons are
located along the top of each menu screen to allow easy programming.
The camera has the following OSD menu structure:
1. EXPOSURE
LENS
E. SHUTTER
BLC
MAX_DR
AGC
SENSE_UP
4. FUNCTION
MIRROR
SHARPNESS
GAMMA
3D DNR
D_ZOOM
SLC
HME
DIS
7. SYNC
SYNC MODE
V_PHASE
Document 800-08379 Rev B
05/11
2. COLOR 3. DAY&NIGHT
WB MODE D&N MODE
R-Y GAIN
B-Y GAIN
5. MOTION 6. PRIVACY
MOTION MASK 1
SET WINDOW MASK 2
ALL SET MASK 3
ALL CLEAR MASK 4
SENSITI. MASK 5
SHOW INDI. MASK 6
DELAY OUT
8. SETUP 9. EXIT
CAMERA ID EXIT
TITLE SAVE&EXIT
DPC FACTORY SET
OMNI LENS*
* HD4DAFS Only
OSD
controller
Monitor out
5