Usb Driver Upgrade Procedure - Optoma EX612 Service Manual

5-1-3 Setup Procedure
1. Set up
- Hold on "MENU" and "POWER" buttons
and plug in the power cord.
- The ON/STANDBY LED will be flashing
green.
- Release "MENU" and "POWER" buttons.
- Connect projector with USB cable.
Note: - The system fan and the lamp will not
operate.
5-1-4 USB Driver Upgrade
Procedure
1. Execute Program
(1) Connect projector with PC by USB
cable.
(2) "Found New Hardware Wiszard" picture
will appear on the screen.
(3) Select "Install the software automatically
(Recommended)".
(4) Click "Next".
(5) Searching picture, please wait for
several seconds.
(6) Click "Finish", then the USB driver has
been installed successfully.
USB port
(2)
(3)
EX612/EX615 Confidential
(4)
5-4