Tuner (G01/G51 Only) And Communications Connections - Meridian G01 Installation Manual

Tuner (G01/G51 only) and communications connections

Use this connection To connect to this
DIN COMMS Other Meridian G Series, 500 Series, or 800 Series equipment, or Meridian DSP loudspeakers.
BNC COMMS Future Meridian components.
RS232 connection A computer, for configuring the control unit or receiver.
USB connection A computer, in future applications.
IR IN A G12 IR Receiver, or approved alternative infra-red repeater. Contact your dealer for details.
ANTENNA FM, AM, or DAB/FM FM and AM or DAB/FM antennae (not applicable to G02 version).
TRIGGER OUTPUT Other equipment, via a mono 3.5mm jack output (centre pin hot) that provides 12VDC (8VDC on G02).
It is always low in standby. By default it is high for all sources, so can be used to bring a G56 or G57
Two-channel Power Amplifier out of standby. Alternatively you can program it to be high for specific
sources; eg to control a projection screen.
1 3
I n s t a l l i n g t h e
c o n t r o l u n i t o r
r e c e i v e r