Table of Contents
Advertisement
Amp assembly replacement continued:
1 2 3 4 5 6 7
4
Here is what it looks like with the seven
cables removed from the amplifi er
assembly. Once again, each cable
must be attached to the same terminal
that it was removed from: (1) yellow,
(2) yellow/black, (3) green, (4) green/
black, (5) blue, (6) blue/black, and
(7) led pcb assembly cable (white cable
next to the blue and black cable).
5
Place the new amplifi er assembly
(part #0013829-00) where the old one
was. Follow the same steps as above,
but backwards 4 to 1. Remove the
serial number from the faulty amplifi er
assembly (as shown in picture above)
and place on the new amplifi er
assembly. Power up the SR1530z and
relish in the fact that you just replaced
an amplifi er assembly. Hats off to you for
a job well done!
6
Important:
The faulty amplifi er
assembly must be returned to LOUD
Technologies. The address should
be on the return shipping label that
was provided with the new amplifi er
assembly. If not, the return address is at
the top of this page. Also, please write
the order number and service request
number (ex: 1046256-1203935) in big,
black, bold numbers on the outside of
the box. This helps expedite the return.
14
Advertisement
Table of Contents
