Dhcp Server - Samsung 4G LTE User Manual

DHCP Server

When enabled, the DHCP (Dynamic Host Configuration
Protocol) server allows your Mobile HotSpot to acquire
network configuration settings from your Wireless Provider's
network automatically.
Important! If you make any changes to the DHCP server
settings, you will need to reboot the HotSpot or
re-start the device and then re-connect.
•
DHCP Server enable: Click or touch to enable.
•
DHCP Address Range: The range of IP addresses reserved for
use by the HotSpot's DHCP server table. If a device with a static IP
address wants to connect to Mobile HotSpot's network, the static
IP should be outside of the DHCP address range. Most devices do
not have a static IP.
Note: The DHCP Adddress range is available only when the
DHCP Address is shown on the Web UI (by default).
When you are located out of the coverage are, you will
have see the following pop-up message "DHCP Address
Range is invalid".
28
•
DHCP Lease Time (in hour): Enter a value to assign a minimum
amount of time (in hours) for which the DHCP server will retain
the IP Address that will be allocated to a particular device.
DHCP Server Buttons
•
Apply: Select to update the settings and apply them.
•
Reset: Select to revert the settings to their previous values.
Data Limit
•
Data Limit: Allows you to set a data limit for connected devices
on your current network. This action limits how much data can be
used by the external device. Enable the Data Limits checkbox,
enter the amount of data in GB and/or MB, then tap Apply.
Data Limit Buttons
•
Apply: Select to update the settings and apply them.
•
Reset: Select to revert the settings to their previous values.