Samsung 4G LTE User Manual page 51

expressed in units of watts per kilogram (W/kg). The FCC
requires wireless devices to comply with a safety limit of 1.6
watts per kilogram (1.6 W/kg).
The FCC SAR limit incorporates a substantial margin of safety
to give additional protection to the public and to account for
any variations in measurements.
SAR tests are conducted using standard operating positions
accepted by the FCC with the device transmitting at its
highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified
power level, the actual SAR level of the device while
operating can be well below the maximum reported value.
This is because the device is designed to operate at multiple
power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base
station antenna, the lower the power output of the device.
Before a new model device is available for sale to the public,
it must be tested and certified to the FCC that it does not
exceed the SAR limit established by the FCC. Tests for each
model wireless mobile device are performed in positions and
locations (e.g. at the ear and worn on the body) as required
by the FCC. For body-worn operation, this device has been
tested and meets FCC RF exposure guidelines when used
with an accessory that contains no metal and that positions
the wireless mobile device a minimum of 1.0 cm from the
body.
Use of other accessories may not ensure compliance with
FCC RF exposure guidelines. The FCC has granted an
Equipment Authorization for this mobile device with all
reported SAR levels evaluated as in compliance with the FCC
RF exposure guidelines. This device has a FCC ID number:
A3LSMV100T [Model Number: SM-V100T] and the specific
SAR levels for this device can be found at the following FCC
website:
http://www.fcc.gov/oet/ea/.
The SAR information for this device can also be found on
Samsung's website:
http://www.samsung.com/sar.
SAR information on this and other model devices can be
accessed online on the FCC's website through
transition.fcc.gov/oet/rfsafety/sar.html. To find information that
pertains to a particular model device, this site uses the
device FCC ID number which is usually printed somewhere
on the case of the device. Sometimes it may be necessary to
remove the battery pack to find the number. Once you have
the FCC ID number for a particular device, follow the
Health and Safety Information
http://
47