Table of Contents
Advertisement
3.2
Defining the VP-311DVI Automatic DVI/Audio Switcher
This section defines the VP-311DVI.
Figure 1: VP-311DVI Automatic DVI/Audio Switcher
#
Feature
1
IR Receiver
2
POWER Switch
3
INPUT SELECT Buttons
4
5
6
7
8
9
RS-232 9-pin D-sub Connector
10
PRIORITY SETUP DIP-switches
11
REMOTE Terminal Block
12
OUT DVI-I Connector
13
IN DVI-I Connectors
14
ETHERNET Connector
15
12V DC
6
BALANCED OUT
Terminal Block
Connector
OUT 3.5mm Mini
Jack
IN 3.5mm Mini Jack
OUT RCA Connector Connect to a digital audio (S/PDIF) output
IN RCA Connectors
Function
The red LED lights when receiving signals from the
Infrared remote control transmitter
Illuminated switch for turning the unit ON or OFF
Press the INPUT button (from 1 to 3) to select the input to
switch to the output
Connects the balanced stereo audio output to a balanced
stereo audio acceptor
Connect to an unbalanced stereo audio output
Connect to unbalanced stereo audio inputs (from 1 to 3)
Connect to digital audio (S/PDIF) inputs (from 1 to 3)
Connect to the PC or the Remote Controller
DIP-switches for setup of the machine: DIPs 1, 2, 3 are
for setting the signal priorities, DIP 4 is for setting to the
manual or the AUTO mode (see
Connects to a dry contact switch (see
Connect to the DVI acceptor
Connect to the DVI sources (from 1 to 3)
Connect to the PC or other Serial Controller through
computer networking
+12V DC connector for powering the unit
Section
4.1)
Section
4.2)
VP-311DVI - Overview
Advertisement
Table of Contents
