Advertisement
SPEAKER INSTALLATION
The speaker should be installed in one of the
following ways depending on location:
Bottom-Mount Locations: If you will be using
the factory speaker wires, it may be necessary to
change the terminations. This may be accomplished
by using an adaptor plug or simply by cutting the
factory connector off and using the supplied crimp
connectors to terminate the speaker wires. The
large connector is for the positive terminal and the
small connector is for the negative terminal of each
speaker. You may also choose to run new speaker
wires. Whichever method you choose, observe
correct polarity in your connections. If you are
unsure about any of these issues, contact your
JL Audio dealer for installation assistance.
IIIWARNING!
Double check the clearance for both speakers
before proceeding. Many cars are different from
one side to the other!
IIIWARNINGI
Hand-tighten the screws evenly in a criss-cross
pattern to avoid bending the speaker frame or
stripping the mounting clips.
4
I
JL Audio -
C2-690tx
Owner's Manual
Your new speakers have been designed to install,
without modifications, into most vehicles that accept
a 6 x 9 inch speaker. Most factory 6 x 9 inch speakers
use four mounting screws or bolts which will line up
with the mounting holes on your C2-690tx speakers.
The speaker should fit so that no air leaks around
the mounting flange. Air leaks will cause a severe
degradation in sound quality.
Seal any air leaks with silicone, rope caulk or
similar sealant material. Install as shown in the
diagram here, using the supplied bottom-mount
spacer rings and the supplied screws and mounting
clips. Hand-tighten the screws evenly to avoid
bending the speaker frame!
Advertisement
