Mono Sub With Active Satellites; Connecting To The Resolv120A Subwoofer - Samson RESOLV 80a Owner's Manual

Connecting to the Resolv120a Subwoofer

Resolv 80a with Mono Sub
Adding a subwoofer and extended low frequency response to your Resolv 80a system is easy using
the RESOLV 80a's LINE LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with
a mixer and a pair of Resolv 80a's satellite speakers. The RESOLV 80a's inputs utilize industry stan-
dard RCA connectors. For a detailed wiring diagram, see the section "RESOLV 80a Connections" on
page 12. Follow the steps in the diagram below to set up your system.
• Lower your mixer's master outputs to all the way off.
• Connect the mixer's left output to the RESOLV 120's LEFT LINE INPUT and the mixer's right
output to the RESOLV 120's RIGHT LINE INPUT. Now connect the RESOLV 120's LEFT LINE
OUTPUT to the input of the left RESOLV 80a, and the RESOLV 120's RIGHT LINE OUTPUT to
the input of the right RESOLV 80a.
• Run an audio signal (like some music from a CD) through your mixer and raise the level to a
comfortable listening level.
• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner's
manual for a recommended crossover point. You can also use your ears by adjusting the
SWEEP control to the frequency that sounds good to you. A good place to start is about 70 Hz.
-27
S/N
10 Inch Long Throw Transducer 120 Watt Amplifier
11
-27
S/N