Installing A Paper Roll - Sharp XE-A137 Instruction Manual

3

Installing a Paper Roll

The register can print receipts. For the printer, you must install the paper roll provided with the register.
I nstall the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
NOTE
(How to set the paper roll)
1.
Remove the printer cover.
2.
Lift up the print roller arm.
3.
Set the paper correctly in the paper roll cradle as per the diagram.
B efore placing a new paper roll in the paper roll cradle, cut off
NOTE
the pasted (taped) part of the paper and confirm that the cut end
of the paper is straight.
4.
Feed the end of the paper along with the paper positioning guides as
per the diagram.
5.
While holding down the paper, slowly close the print roller arm, and
push down the arm until you hear a click locking the arm.
I f the print roller arm is not securely locked, printing is not done
NOTE
right. If this problem occurs, open the arm, and close the arm
as instructed above.
6.
Cut off the excess paper and replace the printer cover.
7. F
Press the key to make sure the paper end comes out of the
printer cover and clean paper appears.
I f the paper end does not come out, open the printer cover,
NOTE
and pass the paper end between the paper cutter and the
paper guide of the printer cover, and replace the printer
cover.
To the printer
Incorrect
(How to cut the paper end)
To the printer
Correct Correct Incorrect
Print roller arm
Paper positioning guides
9