Sharp AL-1651CS Service Manual page 47

5) Disconnect the connector from the MCU PWB.
6) Disengage the pawls (2 positions), and remove the sensor PWB.
3)
1)
7) Remove the screw, and open the upper paper guide.
1)
2)
8) Remove the roller, and remove the belt.
2)
1)
2)
1)
AL-1651CS DISASSEMBLY AND ASSEMBLY 8 - 8
9) Disengage the pawl, and remove the roller knob.
10) Disengage the pawl, and shift the pulley and the bearing.
3)
4)
11) Remove the paper exit roller, and remove the belt, the pulley, and
the bearing.
12) Disconnect the connectors.
13) Remove the three screws, and remove the MCU PWB.
2)
1)
2)
1)
1)
2)
1)
3)
2)
2)
1)