Non-Alarm Functions; Chime Mode; Using The Voice Message Center; Using Macro Keys - Honeywell ADEMCO VISTA-48A User Manual

Security systems

Hide thumbs Also See for ADEMCO VISTA-48A:

Installation and setup manual (80 pages)

Table Of Contents

Table of Contents

Chime Mode

Chime mode alerts you to movement within the premises while the system is disarmed.

Chime Mode on • Security code + [9] (Chime message appears)

• keypads sound three beeps whenever a protected door, window or other specified zone is opened.

• Pressing the [∗] READY key will display the open protection points.

Chime Mode off • Security code + [9] again (Chime message disappears)

• You can set the Voice Touchpads (if installed) to announce faulted (opened) entry/exit or perimeter

Voice Chime:

• [#] + [0] [2] [4] (normal Chime mode must be on first)

Voice Chime

• When Voice Chime is on, faulted zones cause a voice status announcement, chime and display.

on/off

• When off, the sounder still provides chime if normal Chime mode is on.

Using the Voice Message Center

The Voice Keypads feature a voice message center that lets you record and playback one message.

Basic Information

• The message can be up to 2.5-minutes long

• The message remains in the keypad's memory until a new message is

recorded.

• The volume control of the message is adjustable.

• Refer to the procedures below when using the Message Center functions.

Message Center Functions

• [#] FUNCTION + [0] VOICE + [1] RECORD (red MESSAGE LED lights)

Record a

• Message remains in memory until a new message is recorded.

Message

• [1] RECORD (red MESSAGE LED flashes, indicating message waiting)

End Recording

Play a Message • [#] FUNCTION + [0] VOICE + [3] PLAY

• The recorded message plays and the red MESSAGE LED turns off.

• [#] FUNCTION + [0] VOICE + [2] VOLUME keys,

Adjust the

• then press volume key [3] ↑ (up) or [6] ↓ (down)

Volume

• Adjusting message volume also adjusts status volume.

• Volume cannot be adjusted while playing.

Using Macro Keys

See Defining Macro Keys section in the Advanced System Features section for details on defining macro keys.

• The "A", "B", "C" or "D" key may have been pre-programmed as a "macro" key.

Macro Keys

• Macros can be activated only by users authorized to perform the macro's function.

• Press and hold the defined Macro key for at least 2 seconds.

Using a

Macro Key

• Enter your 4-digit user code.

• The programmed macro sequence begins automatically after the user code is entered.

System Devices

Your system may be set up so that it can control certain lights or other electrically operated devices.

About System

Devices

To Activate

• Security Code+ [#] + [7] + nn (nn = 2-digit device number)

Devices

• Devices associated with that device number activate.

To Deactivate

• Security Code+ [#] + [8] + nn (nn = 2-digit device number)

Devices

• Devices associated with that device number deactivate.

zones whenever normal Chime mode is on.

The "Enter User Code" prompt appears and remains displayed for up to 10 seconds.

• Some devices may be automatically turned on or off by the system.

• You may be able to override automatically controlled devices.

• Some devices can be manually turned on or off using the commands described below.

• See your installer for a list of devices that may be set up for your system.