Kenwood TK-780 Service Manual Supplement page 9

Sub LCD display
You can use 3-digit the display to display the system
number, channel number or group number. It is useful
when the main (12-digit) display indicates system, group or
channel name or other functions.
Selective call alert LED
You can select whether or not the LED on the transceiver
flashes in an orange color when selective call was occurred.
PTT ID
PTT ID provides a DTMF or MSK (FleetSync™ : Fleet-ID)
ANI to be sent with every time PTT (beginning of transmis-
sion, end of transmission, or both).
You can program PTT ID for each group. You can pro-
gram a PTT ID as "on" or "off" when "DTMF" is selected
for the PTT ID type. You can program a PTT ID as "own",
"sel" or "off" when "MSK" is selected for the PTT ID type.
The contents of ID are programmed for each transceiver.
The timing that the transceiver sends ID is program-
mable.
BOT : DTMF ID (BOT)/MSK ID is sent on beginning of
transmission.
EOT : DTMF ID (EOT)/MSK ID is sent on end of transmis-
sion.
Both : DTMF ID (BOT)/MSK ID is sent on beginning of
transmission and DTMF ID (EOT)/MSK ID is sent on end
of transmission.
Radio password
When the password is set in the transceiver, user can not
use the transceiver unless enter the correct password.
This code can be up to 6 digits from 0 to 9 and input with
the key, and "S" key.
Off hook decode
If the Off hook decode function has been enabled, re-
moving and replacing the microphone on the hook has no
effect for decoding QT/DQT and option signalling.
Timed power off
This function works as "Automatic Power Switch Off".
Timed power off timer starts from the ignition-off. After
the timer expires, the radio will automatically turn off. The
timer will be reset if the ignition is turned on and off.
This function requires ignition-sense. Connect the igni-
tion-line to the 9-pin connector which is located at the rear of
the radio.
After the timer expires, press the power switch to turn
on the radio.
OPERATING FEATURES
each group. If horn alert has been set to YES for a group and
DEC ID/QT/DQT matches, the horn alert, HOR. is turned on
and off. The group for which the optional signalling is set
works by ANDing the decode ID/QT/DQT with the optional
signalling.
station using 2-tone/DTMF while you are away from your
transceiver, you will be alerted by the vehicle horn or some
other type of external alert. To turn horn alert function on,
press the [Horn Alert] key.
by the FPU. The horn alert port is enabled or disabled as
follows;
(trunking format);
the FPU, pressing the AUX-A key, or setting off hook.
a data transmission except for Selcall. A radio unit can re-
ceive a data message regardless of QT/DQT if the receiving
unit is not scanning.
Horn alert
In trunking format, horn alert can be set to on or off for
In conventional format, if you are called from the base
Either continuous or non-continuous operation can be set
Off hook horn alert Hook off
Enable
Disable
Pulse
The horn alert port, HOR, is turned on and off as follows;
0.5s 0.5s 0.5s 0.5s 0.5s
The timing when the fixed LTR ID matches is as follows
1s 0.5s
Continuous
Horn alert can be reset by setting an expiration time from
Data TX with QT/DQT
Whether programmed QT/DQT is modulated or not with
TK-780/H
Hook on
Yes Yes
No Yes
HOR
1s
9