Kenwood TK-780 Service Manual Supplement page 19

10. Function Setting Mode
All channels can be set up together in the action mode by
using the panel keys.
• Pressing [D] while "SELF PROG" is displayed will change
to function setting mode.
• Press [C] to select a setup item, then press [GRP up/
down] to change selection.
• By pressing [B], the displayed information is stored in
memory and the next item appears. By pressing [C], the
displayed information is not stored and the next item ap-
pears.
• Press [D] to return to the original display ("SELF PROG").
The setup items for function setting mode are listed be-
low.
Setup function Display
(3 character)
[A] A
[B] B
[C] C
[D] D
[SCN] SCN
[MON] MON
[FOOT] FSW
[Grp Up] UP
[Grp Down] DN
[Vol Up] V UP
[Vol Down] V DN
T.O.T TOT
Beep BEP
Off hook decode H_D
Off hook scan H_S
Off hook horn alert H_H
REALIGNMENT
Remarks
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
Various key functions
All TOT settings are turned on
or off.
On : TOT [60s]/Pre-alert [10s]/
Rekey time [5s]/Reset time [5s]
Off : TOT [600s]/Pre-alert [Off]/
Rekey time [Off]/Reset time [Off]
All beep settings are turned on
or off.
On : Power on tone [On]/Control
tone [On]/Warning tone [On]
Off : Power on tone [Off]/Control
tone [Off]/Warning tone [Off]
Enable/Disable
Enable/Disable
Enable/Disable
10-1. Flow Chart
Self programming mode
Function setting mode
[D]
[A] key function
[D]
[B] key function
[D]
[C] key function
[D]
[D] key function
[D]
[SCN] key function
[D]
[MON] key function
[D]
[FOOT] key function
[D]
[Grp Up] key function
[D]
[Grp Down] key function
[D]
[Vol Up] key function
[D]
[Vol Down] key function
[D]
T.O.T on/off
[D]
Beep on/off
[D]
Off hook decode enable/disable
[D]
Off hook scan enable/disable
[D]
Off hook horn alert enable/disable
11. Memory Reset Mode
You can clear all settings you made in self programming
mode, or you can return to the original display.
• Press [SCN] while "SELF PROG" is displayed will change
the display to "CLEAR NO?".
• Press [GRP up/down] to change the display between
"CLEAR NO?" and "CLEAR YES?".
• When "CLEAR YES?" is displayed, pressing [SCN] will
set all data to default, and "ALL CLEAR" will appear on
the display. Press [SCN] again to display "SELF PROG".
• When "CLEAR NO?" is displayed, pressing [SCN] will
cancel the reset, and "SELF PROG" will be displayed.
TK-780/H
[D]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
[B]/[C]
19