Self Programming Mode; Channel Setting Mode - Kenwood TK-780 Service Manual Supplement

TK-780/H

8. Self Programming Mode

Write mode for frequency data and signalling etc. Mainly
used by the person maintaining the user equipment.
8-1. Enter to the Self Programming Mode
Delete R614 (SELF, Figure 3) in the TX-RX unit (B/2) and
turn the power switch on while pressing the [D] key. When
enter the self programming mode, "SELF PROG" is dis-
played.
Note :
This mode (self programming mode) cannot be set when
it has been disabled with the FPU.
TX-RX unit (B/2)
Foil side
R614
IC512

9. Channel Setting Mode

Each channel can be setup in its action mode by using
the panel keys.
• Pressing [MON] while "SELF PROG" is displayed will
change to channel setting mode.
• Press [C] to select a setup item, then press [GRP up/
down] to change the selection.
• By pressing [B], the displayed information is stored in
memory, and the next item appears. By pressing [C], the
displayed information is not stored in memory, and the
next item appears.
• Press [MON] to return to the original display ("SELF
PROG").
18
REALIGNMENT
IC511
Fig. 3
The setup items fro channel setting mode are listed be-
low.
Setup function Display
(3 character)
Channel selection CH or GRP
RX frequency RXF
RX signalling RXS
TX frequency TXF
TX signalling TXS
Scan del/add SCN
Busy channel lockout BSY
RF power PWR
Beat shift SFT
Wide/Narrow W/N
9-1. Flow Chart
Self programming
mode
[MON]
[MON]
Channel setting
mode
[B]
[MON]
RX frequency
[D]
[B]/[C]
[MON]
RX signalling
[B]/[C]
[MON]
TX freuency
[D]
[B]/[C]
[MON]
TX signalling
[B]/[C]
[MON]
Scan delete/add
[B]/[C]
[MON]
Busy channel
lockout yes/no
[B]/[C]
[MON]
RF power high/low
[B]/[C]
[MON]
Beat shift yes/no
[B]/[C]
[MON]
Wide/Narrow
[B]/[C]
Remarks
[D] : Switches frequency on/off
[A] : Changes the step value
between 2.5kHz, 5kHz, 6.25kHz,
7.5kHz, and 1MHz
[D] : Switches between off, QT,
and DQT.
[A] : Switches between 1 step
and standard
[SCN] : Switches between DQT
normal and invert
Same as RX frequency
Same as RX signalling
Delete/Add
Yes/No
High/Low
Yes/No
Wide/Narrow
Channel selection Group selection
[C]
OFF
[D]
OFF QT DQT N DQT I
[D] [D] [S]
OFF
[D]
OFF QT DQT N DQT I
[D] [D] [S]