Seat Depth Adjustment; Check-Out - Sunrise Medical Quickie Freestyle F11 User Instruction Manual & Warranty

26
S. SEAT DEPTH ADJUSTMENT (Seat Frame)
(Figure 30)
The seat depth can be adjusted in one inch increments.
a. Remove the two bolts (A) from each side of the backrest pivot plate.
b. Reposition the backrest to the desired position.
c. Replace and retighten bolts on each side of th backrest pivot plate.
T. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All
accessories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your specified operational
settings (see Operating Guide). If the chair does not perform to specifications, turn the
wheelchair OFF immediately and reprogram operational specifications using the QTRONIX
Programming Pad.
Repeat this procedure until the wheelchair performs to specifications before attempt-
ing active use of the wheelchair.
If you have any problems, follow these procedures:
1. Review the Set-up, Adjustment & Use section and Operating Guide to make sure
chair was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
930583 Rev. D
E n g l i s h
I X . S e t - U p , A d j u s t m e n t & U s e
A
H e a d e r
30