Blodgett MT3255G Installation Operating & Maintenance Manual page 25

Conveyor ovens
Hide thumbs Also See for MT3255G:
Table of Contents

Advertisement

Available languages

Available languages

Figure 26
8. Using the handle supplied with the oven, pull
out the air plate.
Figure 27
9. Remove the nozzles as follows:
a.) Remove the bolt from the hold down
bracket. Lift the bracket straight up and
slide out either end of the oven.
Figure 28
Maintenance
b.) Push the nozzles toward the back wall of
the oven. Lift the front end and turn it to-
ward you slipping the back end from the
duct.
10. Slide the return air diverters out of the oven.
11. Soak the conveyor in a hot water/detergent
mix.
12. Clean the crumb pans, return air diverters,
nozzles, air plates, and end plugs with a hot
water/detergent mix. Rinse with clean water.
For difficult cleaning use a heavy duty de-
greaser or oven cleaner that is safe for alumi-
num.
NOTE: DO NOT immerse the end plugs. They
contain insulation.
13. Clean the oven interior with an all purpose
cleaner or an oven cleaner that is safe for alu-
minum.
14. Move the oven to clean underneath. DO NOT
damage the gas hose or electrical cords when
moving.
Every 12 Months:
A factory authorized service person should:
1. Open and clean the inside of the control panel.
2. Check and tighten all electrical connections.
3. Check DC gear motor brushes for wear.
4. Check conveyor drive chain for cleanliness
and proper lubrication.
If maintenance is required contact your local ser-
vice company, a factory representative or the
Blodgett Oven company.
WARNING!!
Always disconnect the power supply be-
fore cleaning or servicing the oven.
WARNING!!
If the oven needs to be moved, the gas
must be turned off and disconnected from
the unit before removing the restraint. Re-
connect the restraint after the oven has
been returned to its original location.
21
Cleaning

Advertisement

Table of Contents
loading

Table of Contents