Preparing For Use; Electrical Connections; Air-Conditioning Without Installation - DeLonghi PAC N130HPE Instruction Manual

ELECTRICAL CONNECTIONS

Before plugging the appliance into the mains socket, check
that:
• The outlet's power supply corresponds to the value
indicated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• The outlet is a 3-hole grounded outlet . If this is not
the case, you must choose another outlet.
Failure to follow these important safety instructions
absolves the manufacturer of all liability.
The power cable must be replaced by a qualified
professional only.
The instructions below will enable you to prepare your air
conditioner for operation as efficiently as possible. Before
use, make sure the air intake and outlet grilles are
unobstructed.

AIR-CONDITIONING WITHOUT INSTALLATION

Just a few simple steps and your comfort is ensured with your
air conditioner:
Screw the hose adaptor 13 to the hose's end 12.
•
• fit the air exhaust hose in the housing at the back of the
appliance. Insert it as shown in figure A.
A
Screw the window outlet 17 to the other end of the
•
exhaust hose. (see fig. B).
B

Preparing for use

Sash window
• open the window.
• place the window bracket 15 in the window, extending it
to fit the width of the window (fig. C).
• place the air conditioner near the window. Insert the
assembled exhaust hose 12 into the window bracket hole
15.
• Make sure the air exhaust hose is unobstructed.
• If you have a very large window, in order to cover your
window aperture, use the additional window bracket
without holes extending it to the desired dimension,
then fix the bracket by using the locking pin provided.
When extracting the window bracket and joining the two
pieces pay attention you do not cover the hole.
Other set-up methods:
• Thanks to the locking pin, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust
hose (see figure D).
Keep the air hoses as short and free of curves as possible to
avoid constrictions.
5
en
C
D