Sangean WR-2 Instruction Manual page 8

will flash
5. Press Band button and rotary tuning knob to select required radio station . You can also
select alarm station by recalling the preset stations pressing memory presets button .
6. Press and release Set button to complete radio alarm set . Display will show radio alarm
icon
7. The volume level will be same as last radio station listening to .
Monitor radio alarm station
Note: remote control unit is not applicable for this operation
1. Ensure the radio is switched off .
2. Long press the M1 button , until display shows radio frequency . Hold down another 3
seconds, display will flash radio frequency , hold down another 3 seconds to cancel the set
radio station .
3. Display will show
Snooze function
1. Whilst an alarm is sounding , pressing any button ( except the On/Off or Light button ) will
activate the snooze function . The radio or buzzer alarm will be silenced for 5 minutes .
2. The display will flash both the snooze symbol
function can be repeated during the period that the alarms are active .
Cancel alarm setting
Cancel the alarm setting can be done both radio is on or off .
1. When radio is off , press and release Display button , display alarm icon will flash . ( when
radio is on , press Display button to alarm status )
2. Long press SET button until both alarm icon and time digits flash .
3. Press and release SELECT button until display flashes
4. Press SET button again to cancel alarm status . Display alarm icon will disappear after
flashing a couple of seconds .
Sleep timer
The sleep timer will automatically switch off the radio after a preset time has elapsed .
1. Press and continue to hold down the Power On/Off/Sleep button , the display will cycle
or
.
, when no radio station is set .
.
and the alarm symbol . The snooze
.