Sangean WR-2 Instruction Manual page 11

level ( maximum to 60 )
2. Press Volume control once to get into Treble control . Rotary the control until required
treble is reached .
3. Press Volume control twice to get into Bass control . Rotary the control until required bass
is reached .
FM Stereo/Mono button
1. If a station being received is weak , some hiss may be audible . To reduce the hiss , press
and hold down Mono button until radio beeps and display shows MONO .
2. Press and hold down the Mono button to return to Stereo operation .
3. FM stereo is only available when using headphones .
Changing tuning step
Note : remote control unit is not applicable for this operation .
In Europe and other parts of the world , MW tuning steps are 9 kHz , in America , the MW
tuning step is 10 kHz .
On FM , most countries use 100 kHz tuning step , your radio can however be set so as to allow
an FM tuning step of 50 kHz .
1) Adjust FM tuning step
1. Ensure that your radio is switched off . Press and hold down the M5 button until FM step
begins to appear in the display . Hold down the M5 button for another 8 seconds until FM
step begins to flash in the display .
2. Rotary the Tuning control to adjust required FM tuning step ( Rotary down to get 50 kHz
and rotary up to get 100 kHz ) .
3. Press the M5 button again to complete setting . Display will return to clock status after
setting .
Note : remote control unit is not applicable for this operation .
2) Adjust MW tuning step
1. Ensure that your radio is switched off . Press and hold down the M4 button until AM step
begins to appear in the display . Hold down the M4 button for another 8 seconds until AM step
begins to flash in the display .
2. Rotary the tuning control to adjust required AM tuning step ( rotary down to get 9 kHz and
rotary up to get 10 kHz ) .
3. Press the M4 button again to complete setting . Display will return to clock status after
setting .
Change 12/24 hour clock format