Sangean WR-2 Instruction Manual page 6

AC operation
Before you plug the AC cord into the radio , be sure the AC voltage is correct . Insert the plug
on the end of the supplied power cord into the AC power socket on the back of the radio .
DC operation
For outdoors use , you can power the radio by using 12V DC input socket from a DC power
supply ( example , from the power supply of vehicles or boats ) . An AC power adaptor with 1
Ampere and center positive in polarity can also power the radio in house .
Operating your radio
1. The radio display will scroll RDS Setting when the radio is connected to the mains
supply or DC power supply .
2. The RDS (Radio Data System) setting requires approximate one minute to search
required RDS data from radio stations for easier data read out .
3. You can skip the RDS setting by pressing and releasing the power button once
( recommended for non-RDS broadcasting area ) . Display will show -- -- :-- -- for clock
setting .
Clock Setting
1. When radio power is off , long press SET button until display flashes AM 12:00 or 0:00
depending on the sales areas .
2. Press and release Hour and Minute button or rotary tuning control button to set the
required clock time .
3. Press SET button again to complete clock setting . Display stops flashing .
Note : when radio power is on , press Display button to clock mode and follow same
procedures as above for clock setting .
4. Same procedures can be done via supplied remote control unit .
Auto clock set
The RDS equips with auto clock set function , turn on the radio and search for radio stations
with RDS transmitting service , within one minute the clock will show correct time along with
RDS symbol indicating the clock time is RDS time from radio station with RDS service .
Note : RDS service is mainly available in Europe ( including UK ) and part of Northern America
plus some of Asian countries only .
Alarm setting
Note : Alarm setting can be done only when time setting is completed .
initialize radio setting and clock setting