Sangean WR-2 Instruction Manual page 15

1. Switch off the radio .
2. With the aid of a suitable implement ( the end of a paper clip ) , press the RESET button
located on the underside of your radio for at least 2 seconds , this will reset the
microprocessor , clock time and clear all stations stored in the preset memory .
Mute the radio
Press MUTE button on the remote control to mute the radio . Press MUTE button again or
power on/off or volume control to release the muting .
Power failure
The clock will continue to run 6 minutes during power failure while preset stations can last for
approx. an hour . After that , you should reset the radio and preset stations .
Specifications
Frequency Coverage
FM 87.50 108 MHz
AM 520 -1710 kHz ( 10 kHz version ) or
MW 522 1629 kHz ( 9 kHz version )
Powered : AC 120V/60Hz/24W or AC 230V/50Hz 24W
Internal Antenna system
AM built-in ferrite antenna
FM built-in wire antenna
External antenna terminal
AM antenna terminal ( USA version only )
FM F-type antenna terminal
Output power : 7 W 10% T.H.D.@100 Hz
Headphones socket
3.5 mm diameter stereo jack monaural output
Output : 5 mW + 5 mW
Aux In socket :
3.5 mm diameter stereo jack .
Input sensitivity : In 160 mV , Output 7W @ 100 Hz
Input impedance : 47 Kohm
REC out : Output impedance : 2.2 Kohm
DC IN : 12V/1A center pin positive ( operational voltage 9-14V)
Accessories :
FM F-terminal wire antenna
AC power cord
F-PAL terminal adaptor ( European version only )
Dimension : W x H x D in mm : 240 x 115 x 183 .
Weight : 2.6 kgs .