Icom IC-F3 Service Manual page 14

• SCREEN DISPLAY EXAMPLE
Connected battery voltage
Internal temperature
PLL lock voltage
Operating channel
RF output power
FM deviation*
Receive sensitivity
Reference frequency
• CONNECTIONS
to an RS-232C port
OPC-478
DB9 female plug
(incl. level converter circuit)
***** Trimmer Control Software for IC–F3 Series *****
A/D 1 (VIN)
A/D 2 (REMOTE) 255 : FFh
A/D 3 (SD)
A/D 4 (ISENS)
A/D 5 (TEMPS)
A/D 6 (LVIN)
RX:174.00000MHz TX:174.00000MHz
Memory CH : 1
Power(Lo) : 72
Power(Hi) : 142
MOD : 80
BPF 1 : 2
BPF 2 : 54
BPF 3 : 92
BPF 4 : 4
TXF SET :
[TAB] : Display Parameters
[Enter] at TXF : REF Set Mode
NOTE:
The above values for settings are examples only. Each transceiver has its
own specific values for each setting.
DO NOT
* change the value when adjusting the
necessary for the IC-F4/S.
Personal
computer
to [MIC]
to the antenna connector
CAUTION:
DO NOT transmit while
SSG is connected to the
antenna connector.
171 : ABh 10.729V D/A 1 (REF)
5.000V D/A 2 (MODE)
54 : 36h 1.059V D/A 3 (T1)
177 : B1h 2.314V D/A 4 (T2)
186 : BAh 30.353'C D/A 5 (T3)
108 : 6Ch 4.300V D/A 6 (T4/PWR)
PWR : High
[F8] at BPF : Sweep
/ : Cursor Up/Down
Audio generator
AC millivoltmeter
Attenuator
40 dB or 50 dB
RF power meter
10 W / 50
Frequency
counter
Standard signal generator
0.1 V to 32 mV
(–127 dBm to –17 dBm)
5 - 2
120 : 78h 2.353V
131 : 83h 2.569V
192 : C0h 3.765V
198 : C6h 3.882V
204 : CCh 4.000V
114 : 72h 2.235V
Base Freq : 174.00000MHz
[F9] at BPF : Sweep T1~T4
/ : +/– ESC : Quit
IC-F4/S
. A value of 80 is
FM deviation meter