Controls - Midland WR-100 Owner's Manual

CONTROLS:

1. WEATHER/SNOOZE alert, warning tones & 9 minute snooze
button. Press this button to put the weather/hazard receiver into
standby mode (alert monitor mode.) Press button again to return to
hearing National Weather Service weather/hazard voice reports.
- Press this button to cancel alert warning tones and any external alert
features when alert is active.
2. WEATHER SWITCH ON/OFF. Main power switch for Weather
Radio, turns it on & off. (Only the clock is active when this switch
is off.)
3. Volume (UP & DOWN) buttons. Switch Weather Receiver on,
then press these buttons to adjust to desired listening level.
4. "WARNING" Alert Status light ─ Red. Indicates that the National
Weather Service has issued a warning for your area.
5. "WATCH" Alert Status Light ─ Yellow. Indicates that the National
Weather Service has issued a watch for your area.
6. "STATEMENT" Alert Status Light ─ Indicates a S.A.M.E. statement
has been issued for your area by the National Weather Service.
7. MENU button. Press to activate programming mode. (Use
directional arrows to move through programming menu options.)
8. SELECT (programming) button. Press this button to enter the
selected menu mode. Press this button to confirm your menu
option selection.
9. Arrow buttons – directional arrows (up, down, right & left.) Use
directional arrows to move through the Weather Receiver program
menus.
Note you can also use the arrow buttons to review previous alerts
when in normal display mode.
http://www.midlandradio.com
10