Controls - Midland WR-300 - MANUAL 2 Manual

CONTROLS:

Note: The MIDLAND Weather
Radio volume control and the main power switch (# 9 above)
must be turned on to activate the following controls unless
otherwise noted by an asterisk.
1. WEATHER/HAZARD ON/OFF standby mode button.
The Weather/Hazard broadcast & alert receiver is active
whenever the Weather Radio unit is turned on. Press this
button to put the weather/hazard receiver into standby mode
(alert monitor mode.) Press button again to return to
hearing National Weather Service weather/hazard reports.
2. ALERT ON/OFF button. Press this button to cancel alert
siren sounds and any external alert features when alert
active. Press and hold button to enable and disable alert
siren and external alert signals (see Page 20).
When Alert is off, only the LED indicator lights
("Warning", "Watch", & "Statement") are active.
3. SNOOZE clock alarm snooze button. Press to advance the
clock alarm time by 9 minutes each time the clock alarm
sounds.
4. "WARNING" Alert Status light. This red LED Indicator
light tells you that a warning has been issued for your area
by the National Weather Service.
5. "WATCH" Alert Status Light. This yellow LED Indicator
8