Accessories - Ryobi BT3000 Operator's Manual

Following is a list of optional accessories for the BT3000 table saw.
PART NO. DESCRIPTION
4010300 Metal Work Stand
4010330 Work Stand Casters
4650300 36T 10 in. (254 mm) Standard Blade (Carbide Tipped)
4650324 24T 10 in. (254 mm) Rip Blade (Carbide Tipped)
4650340 40T 10 in. (254 mm) Crosscut Blade (Carbide Tipped)
4650360 60T 10 in. (254 mm) Finish Crosscut Blade (Carbide Tipped) 4080330
4070300 Dust Bag
4070330 Dado Throat Plate
4060300 Long Miter Fence
4060330 Stop Block Kit
4710300 Miter Clamp Kit
4730300 Wide Table Kit
4950300 Router and Jig Saw Mounting Kit
These accessories may be ordered through your local RYOBI dealer or Ryobi Authorized Service Center. They have been
specially designed for the BT3000 table saw. Always use recommended RYOBI accessories for highest quality, convenience
and safety. Call Ryobi Customer Service No. 1-800-525-2579 in the United States or 1-800-265-6778 in Canada for your
nearest Ryobi Factory Service Center.
WARNING:
To avoid the risk of personal injury or damage to your saw or work, DO NOT use accessories not recommended by
RYOBI.
EXTENSION CORD CAUTION
When using a power tool at a considerable distance from a power
source, be sure to use an extension cord that has the capacity
to handle the current the tool will draw. An undersized cord will
cause a drop in line voltage, resulting in overheating and loss of
power. Use the chart to determine the minimum wire size
required in an extension cord. Only round jacketed cords recog-
nized by Underwriter's Laboratories (UL) should be used.
When working with a tool outdoors, use an extension cord that
is designed for outside use. This is indicated by the letters "WA"
on the cord's jacket.
Before using any extension cord, inspect it for loose or exposed
wires and cut or worn insulation.
WARNING:
This saw's motor cord must only be plugged into the receptacle provided on the saw which is controlled by the saw's
master switch. Never plug the motor cord directly into an extension cord as this will prevent the ability to switch the
saw OFF.

ACCESSORIES

**Ampere rating
(on tool faceplate)
Cord Length
Keep the extension cord clear of the working area. Position the cord
so that it will not get caught on lumber, tools or other obstructions
while you are working with a power tool.
Page 38
PART NO. DESCRIPTION
4050300 User Kit (Nuts and Bolts)
IDV28 28 Gal. Vacuum
4070333 Zero Clearance Throat
Plate (Set of 2)
4080300 Accessory Table
Accessory Table Clamp
4658718 6-1/2 in. (165 mm) Adjustable Dado
4730305 Wide Table Leg Set
4730310 Quick Fold Table
4730320 Air Flotation/Vacuum Clamp
Table
4060305 Rapid Set Micro-Adjust Device
6360395 Push Block
0-2.0 2.1-3.4 3.5-5.0
Wire Size (A.W.G.)
25' 16 16
50' 16 16
CAUTION
:
**Used on 12 gage - 20 amp circuit.
5.1-7.0 7.1-12.0 12.1-16.0
16 16 14 14
16 14 14 12