User Options - Amana CRC21T2 Service Manual

Programming Instructions

User Options

1. Open oven door. Display shows
"MENU b OR d – READY".
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"Pb" or "Pd" indicating "b" or "d" menu.
3. Press POWER LEVEL pad.
• Displays shows "OP:1(0,1-3)".
• "OP" represents optional program mode, first
number represents option number and second
number represents functions currently selected for
option.
Numbered Display
Pads
1 OP:10
OP:11
2 OP:20
OP:21
3 OP:30
OP:31
4 OP:40
OP:41
5 OP:50
OP:51
6 OP:60
OP:61
7 OP:70
OP:71
OP:72
OP:73
8 OP:80
OP:81
9 OP:90
OP:91
0 OP:00
OP:01
RS2230003 Rev. 1
Options
( ) = Factory Setting
Prevents adding heating time while oven is heating.
(Allows adding heating time while oven is heating.)
Sounds 3 second signal at end of heating cycle.
(Sounds 4 short signals at end of heating cycle.)
(Allows 99 minutes 99 seconds of heating time.)
Allows 10 minutes of heating time.
Prevents signal when pad is pressed.
(Allows signal when pad is pressed.)
(Allows oven to resume heating time countdown after door is opened during cycle.)
Cancels heating time count down after door is opened during cycle.
(Allows use of power levels.)
Prevents use of power levels.
Eliminates end of heating cycle signal.
Sets end of heating cycle signal volume to low.
Sets end of heating cycle signal volume to medium.
(Sets end of heating cycle signal volume to high.)
Sets oven to standard operation. Blower starts when oven starts.
(Sets oven to instant on operation. Blower starts when oven door is opened.)
(Allows use of variable time entry and preprogrammed pads.)
Allows use of preprogrammed pads only.
(Allows lockout to be programmed.)
Prevents lockout from being programmed.
4. Press START pad to advance to next option. See
table for options.
5. Press number pad (0,1-3) to change option.
6. Press START pad to save changes.
• Repeat steps 4-6 to change additional options.
7. Press RESET pad or close oven door to exit
programming mode.
18