Care And Cleaning; Changing Oven Light Bulb; Cleaning Interior, Exterior, And Door; Cleaning Splatter Shield - Amana CRC21T2 Service Manual

Care and Cleaning

Changing Oven Light Bulb

!
To avoid electrical shock hazard unplug power cord or
open circuit breaker to microwave oven before replacing
light bulb. After replacing light bulb, reconnect power.
!
To avoid burns and cuts, wear gloves to protect hands
should bulb break. If hot, allow bulb to cool.
Tools and Bulb
• Protective gloves
• Standard screwdriver or ¼ inch socket
• Light bulb rated 120 volt, 25 watt
1. Unplug oven.
2. Remove screws from back of oven and remove access
cover.
• See figure below.
3. Slide rail out oven from oven cavity.
• See figure below.
RS2230003 Rev. 1
CAUTION
CAUTION
4. Remove bulb by turning counterclockwise, being
careful not to burn fingers or break bulb.
• Replace with bulb rated 120 volt, 25 watt.
5. Slide rail into oven cavity, replace access cover and
screws. When installing screws attach rail to access
cover first, for easier installation.
6. Plug in oven.

Cleaning Interior, Exterior, and Door

!
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
circuit breaker to oven before cleaning.
Clean microwave oven with mild detergent in warm water
using soft sponge or cloth. Wring sponge or cloth to
remove excess water before wiping equipment. If desired,
boil a cup of water in microwave oven to loosen soil
before cleaning.
• Do not use abrasive cleansers or cleaners containing
ammonia. These could damage finish.
• Never pour water into microwave oven bottom.
• Do not use water pressure type cleaning systems.

Cleaning Splatter Shield

Splatter shield keeps top of microwave oven cavity and
antenna from becoming soiled. Clean soil from shield
with damp cloth or clean with mild detergent and water.
Remove splatter shield for easy cleaning.
1. Unplug oven before removing splatter shield to stop
antenna from rotating.
2. Place fingers behind shield, pull forward, and down.
• When removing and replacing splatter shield, be
careful not to bend antenna.
10
WARNING