Ryobi AIRgrip MultiTASKit EMM0001 Operator's Manual page 11

REMOVING/INSTALLING ATTACHMENTS
See Figure 11.
To install an attachment on the vacuum base, align the lock-
ing tabs on the desired attachment to the openings on the
vacuum base so the molded-in arrow is directly centered
above the battery door. Seat the attachment on the base and
rotate until you hear the attachment click into place.
To remove an attachment from the base, depress the release
button on the top of the base, twist the attachment until the
locking tabs on the attachment are aligned with the openings
in the base, then lift to remove.
ATTACHMENT
ARROW
LOCKING
TABS
USING THE LASER LEVEL ATTACHMENT
See Figures 12 - 13.
The laser level attachment will project a straight line across
an obstruction or interference. The line can be rotated 360
degrees by turning the laser attachment in a clockwise or
counterclockwise direction. Re-level the unit for each wall,
adjacent surface, or direction a line is generated towards.
n Place the level in the area where you want the laser line
projected.
n If a true horizontal line is desired, level the tool by center-
ing the bubbles inside the vials located on top of the laser
attachment.
NOTE: To ensure plumb lines, level vial and position the
tool directly in front of the work area.
n Press the on/off button located on top of the laser level
attachment to turn the laser level on.
n Rotate the laser level attachment to position the laser line
where needed.
NOTE: Due to construction inaccuracy, walls may not be
perfectly straight. This may cause the laser to have slight
variances when in the level position.
OPERATION
ATTACHMENT
RELEASE
BUTTON
VACUUM
BASE
Fig. 11
11
Fig. 12
Fig. 13