Hitachi CP-X940W/E Operating Manual page 5

Hitachi operating guide liquid crystal projector cp-x940w/e
Table of Contents

Advertisement

High temperatures are generated
when the lamp is lit, so do not place
objects in front of the lens.
Be careful in handling the power cord.
• Do not scratch, damage or process the power
cord. Do not bend it forcibly. Also do not put a
heavy object on it, do not heat it and do not pull
it. If you do, the power cord may be damaged and
it may cause a fire, electric shock, etc.
⋅ Do not pull the cord.
⋅ Do not put a heavy object on it.
⋅ Do not damage the cord.
⋅ Do not put it near a heating
device.
• Be careful that this unit is not placed
on the power cord. The power cord may be
damaged and it may cause a fire, electric shock,
etc. If the cord is covered with a carpet, etc. a
heavy object may be put on it without your
realizing it.
Do not stare directly into the laser aperture.
• The laser pointer on the remote control unit radiates the laser beam from the laser
aperture.
• Do not stare into the laser aperture or radiate the laser beam to other persons as the
laser emitted is a class 2 laser and it could damage you vision , etc.
Especially pay attention if children are present.
• The three labels below are caution labels for the laser beam.
Warning
• If the cord is damaged (core wire is
• Check that no dirt adheres to the
• The outer shield of power cord must be
AVOIDE EXPOSURE-LASER
RADIATION IS EMITTED
FROM THIS APERTURE
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
WAVE LENGTH : 670nm
MAX. OUTPUT : 1mW
IEC60825-1 : 1993 + A1 : 1997
exposed, disconnected, etc.), ask
your dealer to replace it. It may
cause a fire, electric shock, etc.
power plug and fully insert without any play. If
dirt adheres or the connection is incomplete, it
may cause a fire, electric shock, etc.
connected to ground.
If you do not, it may cause a
electric shock.
RADIAZIONI LASER
CAUTION
NON GUARDARE NEL RAGGIO LUCE
APPARECCHIO LASER DI CLASS 2
RAYONNEMENT LASER
LASER RADIATION -
NE PAS REGARDER DANS
DO NOT STARE INTO BEAM
LE FAISCEAU APPAREIL
WAVE LEGTH : 670nm
A LASER DE CLASSE 2
MAX. OUTPUT : 1mW
LASER-STRAHLUNG
NICHT IN DEN STRAHL
CLASS 2 LASER PRODUCT
BLICKEN LASAER KLASSE 2
LASER APERTURE
MANUFACTURED
Jun-99
PLACE OF
MANUFACTURER:
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-x940wCp-x940e

Table of Contents