Hitachi CP-X940W/E Operating Manual page 11

Hitachi operating guide liquid crystal projector cp-x940w/e
Table of Contents

Advertisement

Names and functions of each part (continued)
How to insert batteries
Insert the provided batteries (LR6 (alkal) into the remote control transmitter.
Remove the battery
1
compartment cover.
Slide the battery compartment cover
in the direction of the arrow while
pressing slightly down on it.
Cautions on use of batteries
Caution
• Do not use batteries not specified for this unit.
Also do not use old and new batteries together.
It may cause a fire, injury due to burst of
battery or liquid leakage.
• When inserting batteries, pay attention to the
direction of the
and
and insert the batteries correctly. If the
polarities are confused, it may cause injury or
damage near the unit due to a burst of battery
or liquid leakage.
Caution
• The laser pointer on the remote control unit radiates the laser beam from the laser aperture.
• This laser pointer used as a stick (for indication).
Do not stare directly into the laser aperture or radiate the laser beam to other persons as the laser
emitted is a class II laser and it could damage you vision , etc.
Especially pay attention if children are present.
• The three labels below are caution labels for the laser beam.
polarity indications
Cautions on use of the laser pointer.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
WAVE LENGTH : 670nm
MAX. OUTPUT : 1mW
IEC60825-1 : 1993 + A1 : 1997
Insert the batteries
2
as illustrated inside
the battery compartment.
Replace the cover.
3
Cautions on use
Caution
• Do not drop the remote control transmitter or
apply any shock to it.
• Do not let the remote control transmitter get
wet and do not put it on a wet object. It may
cause a malfunction.
• If you are not going to use it for a long time,
remove the batteries from the remote control
transmitter.
• If operation of the remote control becomes
difficult, replace the batteries.
CAUTION
LASER RADIATION -
DO NOT STARE INTO BEAM
WAVE LEGTH : 670nm
MAX. OUTPUT : 1mW
CLASS 2 LASER PRODUCT
AVOIDE EXPOSURE-LASER
RADIATION IS EMITTED
FROM THIS APERTURE
LASER APERTURE
RADIAZIONI LASER
NON GUARDARE NEL RAGGIO LUCE
APPARECCHIO LASER DI CLASS 2
RAYONNEMENT LASER
MANUFACTURED
NE PAS REGARDER DANS
LE FAISCEAU APPAREIL
Jun-99
A LASER DE CLASSE 2
LASER-STRAHLUNG
PLACE OF
NICHT IN DEN STRAHL
MANUFACTURER:
BLICKEN LASAER KLASSE 2
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-x940wCp-x940e

Table of Contents