Hitachi CP-X940W/E Operating Manual page 18

Hitachi operating guide liquid crystal projector cp-x940w/e
Table of Contents

Advertisement

Adjustments and functions (continued)
< AUTO-adjustment >
The projector will automatically adjust four items (V POSIT, H POSIT, H PHASE, H SIZE, White level).
When AUTO is selected (the cursor is moved from Manual Operation towards the right) the AUTO Confirm
screen shown below will be displayed.
< AUTO-adjustment Confirm Screen >
While the AUTO confirmation screen is displayed as illustrated on the
upper right, if you shift the cursor upward and select AUTO, the projector
will perform auto-adjustment.
It will become as illustrated on the lower right.
If CANCEL is selected for three seconds, or if the RESET button on either
the unit or the remote control is pressed, the green cursor will return to
the value for the selected item (Manual Operation)
< During AUTO-adjustment >
At the lower right of the screen the word <AUTO> will flash in green
letters.
When the auto-adjustment is completed the word <AUTO> will disappear.
The auto-adjustment of the white level is cancelled by input switching and
signal mode change.
• When start up screen is displayed ("NO INPUT IS DETECTED" or "SYNC IS OUT OF
Caution
RANGE" is displayed), SETUP menu items other than VOLUME cannot be set.
• TINT cannot be adjusted with PAL/SECAM video signal input.
• TINT, COLOR and SHARPNESS cannot be adjusted with an RGB signal input.
• V.POSIT, H.POSIT, H.PHASE and H.SIZE cannot be adjusted with a VIDEO signal input.
• Auto-adjustment will take about 10 to 15 seconds to complete.
• In some cases auto-adjustment may not function normally, depending on the type of
computer to which the unit is connected, and the signal sent.
• Auto-adjustment may not perform normally with some images. Do not use with animated
or dark images.
• Carry out the auto-adjustment when the application, which is activated on the computer, is
set to the maximum display.
• After auto-adjustment the screen may become slightly dark due to the auto-adjustment of
the signal level.
• Auto-adjust can not be performed during freeze, during magnify, or during the initial
screen display ("NO INPUT IS DETECTED" or "SYNC IS OUT OF RANGE").
INPUT
Adjustment Item
RGB 1
RGB 2
VIDEO
SYSTEM
18
The menu INPUT serves for the selection of input source.
S E T U P I N P U T I M A G E O P T .
RGB1
RGB2
VIDEO
Selects the RGB 1 terminal.
Selects the RGB 2 terminal.
Selects the VIDEO terminal.
Selects the video signal systems. In normal circumstances, select AUTO. AUTO does not
support N-PAL.
When the picture (Video) is abnormal (no color), selects the input signal mode (NTSC,
PAL, SECAM, NTSC4.43 M-PAL and N-PAL). To input N-PAL signals, select N-PAL.
SETUP INPUT IMAGE OPT.
S Y S T E M
RGB1
AUTO
NTSC
RGB2
PAL
V I DEO
SECAM
NTSC4.43
M-PAL
N-PAL
Details of adjustment
S E T U P I N P U T I M A G E O P T .
VOLUME
BRIGHT
CONTRAST
123
V POSIT
AUTO
AUTO
H POSIT
111
CANCEL
H PHASE
31
H SIZE
1024
COLOR BAL
R
AUTO
B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp-x940wCp-x940e

Table of Contents