Westerbeke 8.0KW-60Hz Service Manual page 28

ENGINE-DISASSEMBLY, INSPECTION AND ASSEMBLY
FRONT OIL SEAL CASE INSTALLATION
APPLY A 3MM
BEAD OF F1P GASKET_ • .
UJ'-"
FRONT OIL SEAL INSTALLATION
-SPECIAL
TOOL
Apply engine oil to the 01 sea! lip, then push the oil· seal
along the guide by hand until it touches the front case. Tap
the oil seal into place using the special
tool.
OIL PAN
OIL PAN INSTALLATION
APPLY A 4MM BEAD
OF GASKET
Before insLalling the oil pan, inspect the oil pan drain hose
and fittings for cracks and wear, replace if necessary.
Clean the mating surfaces of the cylinder block and oil pan.
Apply a 4mm bead of fonn·in-place gasket to the outer
circumference of the oil pan flange.
INSTALL A NEW OIL FILTER
Screw the oil filter in until the sealing gasket contacts the
front case, then tighten 3/4
turn.
SPIN·ON
OIL FILTER.
SEALING GASKET
APPLY CLEAN OIL
WHEN ASSEMBLING
-..v-
WESTERBEKE
Engines & Generators
21