Westerbeke 8.0KW-60Hz Service Manual page 27

ENGINE-DISASSEMBLY, INSPECTION AND ASSEMBLY
OIL PAN REMOVAL
1. Remove the oil pan mounting bolts.
2. Knock the special tool between the oil pan and cylinder
block as shown in the illustration.
3. Thpping the side of the special tool slide the tool along the
oil panlcylinder block seal and remove the oil pan.
SEPARATING THE
fi
OIL PAl
APPLY CLEAN OIL
WHEN ASSEMBLING
FRONT Oil
.~ S~
~
OIL PUMP INSPECTION
1. Fit the rotor into the front case.
4
Oil PAN GASKET TOOL
6
FRONT CASE .
WHEN REASSEMBLING,
APPLY CLEAN OIL TO ALL
MOVING PARTS.
RELIEF VALVE ASSEMBLY
2. Check the tip clearance using a thickness gauge.
STANDARD VALUE: 0.06· 0.18mm (0.0023· 0.0070In)
3. Check the side clearance using a straight edge and thick·
ness gauge.
STANDARD VALUE: 0.04· 0,10mm (0.0015· 0,0039In)
~~~STRAlGiHT
EDGE
4. Check the body clearance using a thickness gauge.
STANDARD VALUE: 0,04· 0,10mm (0,0015· 0.0039in)
LIMIT: O.35mm (0.13In)
CHECKING THE
BODY CLEARANCE
...v: WESTERBEKE
Englnee & Generators
20
CHECKING THE SIDE CLEARANCE