Suzuki SP-67 Owner's Manual page 48

RECORD
MEL 1 MEL 2
ACCOMP
ACCOMP MEL 1
PLAY/STOP
RECORD
48
RECORDING (continued)
4. Record - Your performance can be recorded in the following ways:
Record Melody Track Only
If the MELODY 1 or MELODY 2 buttons are selected the record-
ing will begin as soon as you play on the keyboard.
Please note, turn the fingering mode to off when recording on a
melody track alone. When the fingering mode is set to Fingered
or Single, the auto accompaniment section of the keyboard will
not be record.
Record Auto Accompaniment Track Only
If only the ACCOMP track button has been selected, the auto
accompaniment will be on synchronized start mode. Recording
will start as soon as a chord is played on the auto accompaniment
section of the keyboard. Press the INTRO/ENDING button to add
an introduction. Any performance, such as style change, tempo,
fill-ins and ending will be recorded. During recording, pressing
the INTRO/ENDING button will stop the recording with an ending
pattern.
Please note, notes played on the Melody section of the keyboard
will not be recorded in the auto accompaniment track. If the auto
accompaniment is off, only the percussive rhythm will be re-
corded. An unrecognized chord in the fingered mode cannot start
the recording.
Record the Auto Accompaniment and a Melody Track
If you want to record a melody and the accompaniment at the
same time, Press a MELODY track button, then the ACCOMP
track button and both indicators will blink on standby. Recording
begins as soon as you start to play on any section of the key-
board.
Please note, all contents in a track will be erased as soon you
start to record on that track, replaced by the new recording.
5. Stop Recording - Press the START/STOP button, the PLAY/
STOP button or the REC button again to stop recording. When
the accompaniment track is being recorded, press the INTRO/
ENDING button to stop the recording with an ending pattern in
the accompaniment track.
Please note, when the record memory is full, recording will stop
automatically and "End" will appear on the display screen.