RocketFish RF-WHTIB-A User Manual page 17

Problem
Sound interference
No communication between
the sender and receiver
Solution
• Move the wireless sender and wireless receiver slowly
to find the best reception position for your system.
• Shorten the distance between your wireless sender and
wireless receiver. The maximum distance is 100 feet.
• Other devices, such as cordless phones or microwaves,
may cause interference with the wireless sender and
wireless receiver. Try turning off one device at a time to
determine which device is causing interference. Make
sure the wireless sender is more than 18 inches away
from any Wi-Fi routers.
• Make sure that the power cords are connected
correctly.
• After the power switches have been turned on on both
the wireless sender and wireless receiver, the front
panel LEDs should light. If they are solidly on, a
communication link has been successfully established
between the units. If they are flashing on one or both
units, press and hold the CONNECT button on either
the wireless sender or wireless receiver for two
seconds. (Both the wireless sender's and the wireless
receiver's CONNECT buttons are on the bottom.) This
will put the unit into the "connection mode" for about
30 seconds. During this period the CONNECT button
on the other unit must also be pressed for two seconds
so that it will also enter "connection mode. " The system
proceeds with the connection process between the
wireless sender and wireless receiver. While in
"connection mode, " the LED indicators blink at a faster
rate. When an active link is established between the
wireless sender and wireless receiver, the LED
indicators will be solid on and will not blink.
Note: Try pressing the CONNECT buttons again if the LED indicators keep
blinking after 30 seconds.
RF-WHTIB-A
17