Advertisement

Quick Links

GB
IMPORTANT
• After removing the packaging, make sure the appliance
is complete and undamaged. If in doubt, do not use the
appliance and contact qualified personnel only.
• Dispose of the plastic bag with care as it represents a
hazard for children.
• If the socket and power cable plug are incompatible, the
socket should be changed for a suitable type by quali-
fied personnel only who should ensure that the cross-
section of the wires leading to the socket is suitable for
the power absorbed by the appliance.
• Bear the following fundamental safety rules in mind:
-
Never touch the appliance with damp hands.
-
Never use the appliance with bare or wet feet.
-
Never unplug the appliance by pulling the power
cable or the appliance itself.
-
The appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance.
-
Never leave the appliance plugged in as it could be
a safety hazard.
-
Never place the iron under the tap to top up with
water. Always use the measure provided.
-
If the power cable is damaged, have it replaced
immediately by a qualified electrician.
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FXN 25AG and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DeLonghi FXN 25AG

  • Page 1 IMPORTANT • After removing the packaging, make sure the appliance is complete and undamaged. If in doubt, do not use the appliance and contact qualified personnel only. • Dispose of the plastic bag with care as it represents a hazard for children. •...
  • Page 2 The safety of this appliance is guaranteed only if correctly connected to a proper and effective earth connection as specified by current electrical safety standards and regulations. This fundamental safety requisite should be verified. If in doubt, ask a quali- fied electrician to check the mains system tho- roughly.
  • Page 3: Main Components

    • When placing the iron on the iron rest, make sure the iron rest is located on a stable surface. The iron should be placed on a flat surface extremely resistant to high temperatures. This appliance complies with directive 89/336/EEC on radio interference suppression.
  • Page 4: Steam Ironing

    STEAM IRONING This iron works with normal tap water. a) Before filling the tank, make sure the steam regulator E is in the position ("dry" position) (fig. 1). Make sure the power cable is unplugged from the mains socket. b) Open the cover of the opening D and pour the water into the iron (fig.
  • Page 5: Dry Ironing

    the dry position Note: On the back of the iron there is a useful guide giving information on the temperature to set according to the garment being ironed: Ricordatevi che la funzione vapore può essere impiegata solo con termostato posizionato sul settore DRY IRONING •...
  • Page 6: Vertical Ironing

    VERTICAL IRONING Enables delicate garments to be steamed without resting them on the ironing board: pay attention to the temperatu- re used to steam hanging fabrics. Position the steam regulator E on the dry position Rotate the thermostat knob H clockwise as far as it will go (maximum steam position).
  • Page 7: Maintenance And Cleaning

    • Open the cover and empty the iron, holding it point downwards and shaking it gently over a basin or sink. • To dry the remaining moisture, turn the iron on again with the thermostat in the maximum position for about two minutes with the steam regulator in the MAX posi- tion.
  • Page 8 • release the SELF CLEAN button; • plug the appliance into the mains and leave in opera- tion for at least two minutes to dry the plate. • at the end, unplug the appliance from the mains. Leave the iron to cool and clean the outside with a soft cloth. SCALE PREVENTION SYSTEM (ANTICALC) The appliance is fitted with a permanent resin scale filter in the tank.
  • Page 9 ELECTRICAL CONNECTION (UK ONLY) If your appliance comes fitted with a If the plug is a moulded-on type, the plug, it will incorporate a 13 Amp fuse. fuse cover must be re-fitted when If it does not fit your socket, the plug changing the fuse using a 13 Amp should be cut off from the mains lead, Asta approved fuse to BS 1362.

Table of Contents