Bridge Media Function - Hitachi C47-WD8000 Instruction Manual

Rear projection color tv
Hide thumbs Also See for C47-WD8000:
Table of Contents

Advertisement

BRIDGE MEDIA FUNCTION

The TV provides two kinds of methods to view still or motion pictures from your digital camera.
1. Connect your digital camera or card reader to the PHOTO INPUT
using a USB cable.
2. Insert the SD or MMC card into SD memory card slot as shown below.
USB slot
SD memory
card slot
Usage
1.Please turn off the power or set the TV in standby before using this function.
2.Set the digital camera to the same state as when connecting to PC, which is described in the digital camera
instruction manual. Then turn off the digital camera.
Note: Please insert memory card into card reader before connecting the card reader.
3.Connect your digital camera to the USB slot using a USB cable. Then turn on the power of the TV and the
camera. Some camera need to be turned on before connecting to the USB cable, please refer to the camera
instruction manual. If you do not follow the instructions stated in the camera instruction manual, it may be
abnormal.
Note: Refer to the above illustration for using SD or MMC memory card. Turn on the TV after inserting the
memory card into the SD memory card slot.
4.If display is normal, the bridge media status indicator will
light up after a few seconds.
5.To use the photo display function:
1) PHOTO BROWSE
Press the TV/PHOTO button to switch the TV from TV
mode to photo display mode. A
left top of the screen for a while and the first sixteen photos
will be shown on the screen. (If the photos stored in the
memory card are less than 16, the TV will display the
photos available only.) Press the Page up/down buttons to
show the next page of photo display. Select one of the
sixteen photos using the
number buttons), the frame of the selected photo will be
indicated in green. Press the ENTER button to display the
selected photo as shown on the right. The related
information of this photo will appear on the lower right
corner of the photo when the RECALL button is pressed.
For example, the information of this photo indicates as
follows:
No. 1/6
There are six photos in total, this is the first
05/05/28
May 28, 2005
1600 1200
Pixels :1600 1200
Note
SD
Insert the memory card to the slot with its right-side
facing.
To remove the memory card
Push the memory card, and then pull out the memory
MMC
card.
symbol will appear on
cursor buttons (or
one.
38
(USB slot) on the side panel of the TV
No. 1/ 6
05/05/28
1600 1200

Advertisement

Table of Contents
loading

This manual is also suitable for:

C57-wd8000

Table of Contents