Ch Surf Function; Mode 3 - Hitachi C47-WD8000 Instruction Manual

Rear projection color tv
Hide thumbs Also See for C47-WD8000:
Table of Contents

Advertisement

CH SURF FUNCTION

The CH Surf function of this TV provides two modes, mode 3 and mode 12. To use this function allows you to
enjoy the programs easily and comfortably.
In normal picture mode, press the CH SURF button to enter mode 3 or mode 12.

Mode 3

Follow the steps on page 20 to enter the Function menu and
select the Multi Picture option, then enter the Multi Picture
menu and select the CH Surf option as shown on the right.
Press the
cursor buttons to set the CH Surf option
to mode 3, then exit from the menu.
In normal TV mode, press the CH SURF button to enter
mode 3 (4-Picture display mode) as shown below.
Picture A will display the current active program. The
speakers and the headphone jack will output the sound
from picture A. The monitor out terminals will output
audio and video signals from picture A too.
Picture B1, B2 and B3 will rotate to refresh individual
program after a few seconds starting from the program
No.0, except those programs that are skipped.
When entering mode 3, you can select the program for
picture A by pressing the program up/down buttons
or number buttons. As for the pictures in group B, you can
press the
P+
P- buttons to select one of the pictures
among the B1, B2, B3 picture. The color of the program
No. in the selected picture will turn from white to green. If
you press the ENTER button, the picture selected in
group B will be switched to the picture A.
In this mode, press the CH SURF or the RETURN button to quit.
In this mode, you can enter the Audio menu to perform the adjustment. However, if you enter other menus
such as Picture, it will exit from the 4-Picture display mode.
In this mode, the A/B, SWAP and POSITION buttons are invalid.
Note: Not all input signal formats are valid for mode 3. Sometimes the signal may be able to be displayed in TV
mode before entering mode 3, it may not be able to be displayed once in mode 3. In such case, the
characters !Invalid Signal will appear in picture A, or the
normal.
A
symbol will appear in picture B. This is
36
B1
B2
B3

Advertisement

Table of Contents
loading

This manual is also suitable for:

C57-wd8000

Table of Contents