LG WDM-124405TDS Owner's Manual page 30

T roubleshooting guide
Symptom
• Water supply is not adequate in
• Water supply taps are not
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are
• If water leakage occurred in the inlet hose,
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an unbalance detection
• If the laundry is still too wet at the end of the
• Water overfills due to the faulty water
• Water level sensor has malfunctioned.
• Over load in motor.
• Water leaks
• The washer experienced a power failure.
Possible Cause
area
completely open.
clogged.
indicator " " will be changed red color.
and correction system. If individual heavy
articles are loaded (ex. bath mat, both robe,
etc.), this system may stop spinning or even
interrupt the spin cycle altogether.
cycle, add smaller articles of laundry to
balance the load and repeat the spin cycle.
• Is the door opened or not
completely closed?
valve.
<Fig 1>
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose(s).
Clean and straighten the drain hose.
Clean the drain filter.
For more detailed information,
please refer to "The drain pump filter"
on page 24
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
Close the door completely.
❋ If "
"is not released, call for service.
Unplug the power plug and call for service.
Close the water tap.
Unplug the power plug.
Call for service.
Call for service.
Restart the cycle.
Solution
29