NETGEAR ProSafe Premium WNDAP660 Reference Manual page 21

ProSafe Premium 3 x 3 Dual-Band Wireless-N Access Point WNDAP660
A
Ethernet cable
Figure 7.
5. Turn on your computer.
6. Connect the power adapter to the wireless access point.
Tip: The wireless access point supports Power over Ethernet (PoE) with
power redundancy. Both Ethernet ports can provide power. If you have a
switch that provides PoE, you do not need to use the power adapter to
power the wireless access point. Using PoE can be especially
convenient when the wireless access point is installed in a high location
far away from a power outlet.
7. Verify the following:
Power/Test LED. The Power/Test LED blinks when the wireless access point is
first turned on. (To be exact, during startup, the LED is first steady amber, then
goes off, and then blinks green.) After about 45 seconds, the LED should stay lit
(steady green). If after 1 minute the Power/Test LED is not lit or is still blinking,
check the connections and see if the power outlet is controlled by a wall switch
that is turned off.
Active LED. The Active LED is lit or blinks green when there is Ethernet traffic.
LAN 1 LED. The LAN LED indicates the LAN speed for LAN port 1: green for
1000 Mbps, amber for 100 Mbps, and no light for 10 Mbps. If the LAN LED is not
lit, make sure that the Ethernet cable is securely attached at both ends.
LAN 2 LED. The LAN LED indicates the LAN speed for LAN port 2: green for
1000 Mbps, amber for 100 Mbps, and no light for 10 Mbps. If the LAN LED is not
lit, make sure that the Ethernet cable is securely attached at both ends.
B
Ethernet port
Installation and Basic Configuration
21