Appliance Break-In; Heat Management; Detailed Component Operating Instructions - Outdoor Lifestyles TWILIGHT-II-B Owner's Manual

F. Appliance Break-In
Initial Break-in Procedure
• The fireplace should be run three to four hours
continuously on high.
• Turn the fi replace off and allow it to completely cool.
• Remove fi xed glass assembly. See Section 4.
• Clean fi xed glass assembly. See Section 4.
• Replace the fi xed glass assembly and run continuously
on high an additional 12 hours.
This cures the materials used to manufacture the fi re-
place.
NOTICE! Open windows for air circulation during fi re-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
G. Heat Management
Burn Rate
The TWILIGHT-II-B has a constant burn rate which is
controlled by the gas valve. Therefore the fl ame height is
not adjustable.
FIREPLACE
OPENING
Figure 3.3. Maximum Interior Wall Surface Temperatures Above
Appliance
Outdoor Lifestyles by Hearth & Home Technologies • Twilight-II-B Owner's Manual • 2108-971 Rev. E • 11/13
10
TO CEILING
120°F
130°F
140°F
48 in.
42 in.
150°F
36 in.
160°F
30 in.
180°F
24 in.
18 in.
200°F
12 in.
6 in.
MEASUREMENTS FROM
TOP EDGE OF THE OPENING
APPLIANCE FRONT
H. Detailed Component Operating
Instructions
IntelliFire™ Ignition System
IntelliFire™, an ignition system exclusively featured in
Heatilator, Heat & Glo & Quadra-Fire products, is an
energy-saving pilot ignition system for gas fi replaces and
inserts. It provides an ignition fl ame only when needed
and has a battery backup system that supplies power to
spark the ignition fl ame in the event of a power outage.
Intellifi re™ is an intermittent pilot ignition, which is an
electronic system. The term Intermittent is used because
the pilot burner fl ame is only present when the main
burner is operating. When the main burner is off the pilot
is also off.
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Appliance ON/OFF:
If an optional remote control or wall control is installed,
it should be used to control the ON/OFF function of the
appliance. Follow instructions included with the installed
control.
To operate the appliance without a wall control or remote
control, use the ON/OFF switch located inside the control
cavity of the appliance. See Figure 3.4.
Access to the ON/OFF switch may vary depending on the
choice of decorative front. In some cases a louver may
need to be opened. In other cases, the decorative front
may need to be removed.
CAUTION! Risk of Electric Shock! Avoid touching wires
and electrical components in appliance control cavity.
Figure 3.4. ON/OFF Switch Location
ON/OFF
SWITCH